AVAILABLE AT

Installation Tips

02

Before installing a disc, clean both sides with water at room temperature or with non-detergent liquid cleanser.

01

03

When rectifying or polishing the discs, make sure that the top has a non-directional finish without grooves.

Do not touch the friction layer with the hands or objects contaminated with lubricants.

05

Inspect the components and replace all worn hardware including clamps, pistons, o-rings, guides, retainer clips and other fittings.

04

06

Lubricate with the appropiate product the sliding surfaces and if necessary the metal plate of the brake pads.

Open the drainage and then compress the pistons. Do not pound the pads with steel hammers to adjust them on their place.

08

This product does not require high-speed settlement.

 

07

09

Tighten the screws using the star pattern suggested.

Check the temperature of all brakes to ensure a balanced braking effort.

DISPONIBLES TAMBIÉN EN

01

02

When rectifying or polishing the discs, make sure that the top has a non-directional finish without grooves.

Before installing a disc, clean both sides with water at room temperature or with non-detergent liquid cleanser.

03

Do not touch the friction layer with the hands or objects contaminated with lubricants.

04

Lubricate with the appropiate product the sliding surfaces and if necessary the metal plate of the brake pads.

05

Inspect the components and replace all worn hardware including clamps, pistons, o-rings, guides, retainer clips and other fittings.

06

Open the drainage and then compress the pistons. Do not pound the pads with steel hammers to adjust them on their place.

07

Tighten the screws using the star pattern suggested.

08

This product does not require high-speed settlement.

 

09

Check the temperature of all brakes to ensure a balanced braking effort.